Raspberry base install
From Rsewiki
(Difference between revisions)
(Created page with "== Installation from blank SD-flash == === Install Raspberry === Use Raspberry pi imager (download from https://www.raspberrypi.com/software/) rpi-imager First configure...") |
(→Start Raspberry) |
||
Line 47: | Line 47: | ||
− | In this case, the IP4 is 10.197.217.175. | + | In this case, the IP4 (inet) is 10.197.217.175. |
− | If you don't get an IP, the wifi may not be set correctly. | + | If you don't get an IP, the wifi may not be set correctly (see the wifi setup). |
Revision as of 14:59, 12 August 2023
Installation from blank SD-flash
Install Raspberry
Use Raspberry pi imager (download from https://www.raspberrypi.com/software/)
rpi-imager
First configure settings: click the gear icon, and set:
- enable ssh, hostname, English language, Danish keyboard, possibly SSID, time zone, username (local) and password (remember to spell the password correctly).
then
Select operating system 'Raspberry Pi OS lite' and storage, an empty SD-flash of at least 16GB, then write.
When finished, mount the SD into the Raspberry
Start Raspberry
If everything is configured as above, then you just need to figure out the IP. On a Linux computer, you can find the Raspberry IP address using (if on the same local net):
sudo apt install net-tools nmap nmap -sP 192.168.2.0/24
else
You need a screen and keyboard.
Log on to the Raspberry Pi
$ ifconfig eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 ... lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 ... wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 10.197.217.175 netmask 255.255.252.0 broadcast 10.197.219.255 inet6 fe80::f620:b431:69cc:44f4 prefixlen 64 scopeid 0x20<link> ether dc:a6:32:f4:0e:a4 txqueuelen 1000 (Ethernet) RX packets 486 bytes 41505 (40.5 KiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 421 bytes 43403 (42.3 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
In this case, the IP4 (inet) is 10.197.217.175.
If you don't get an IP, the wifi may not be set correctly (see the wifi setup).