ASTA pool
(→Filer maintenance) |
|||
| Line 41: | Line 41: | ||
2.2 Take the drain pipe and mount it. | 2.2 Take the drain pipe and mount it. | ||
| − | 2.3 Open the valve. | + | 2.3 Open the blue valve. |
| + | |||
| + | [[File:filter_backwash.jpeg | 200px]] | ||
| + | |||
| + | 3. Switch the filter to position 2 - backwash. | ||
| + | It will reverse the flow in the filter and dump the debris into the drain-pipe. | ||
| + | |||
| + | Turn on the pump and let it stay in that position for 1-2 minutes. | ||
| + | |||
| + | [[File:filter_rinse.jpeg | 200px]] | ||
| + | |||
| + | 4. Turn off the pump and switch to position 3 - rinse. | ||
| + | It will use the normal flow in the filter, but dump any debris that in the filter output to the drain. | ||
| + | |||
| + | Turn on the pump for 10-20 seconds. | ||
| + | |||
| + | [[File:filter_filter.jpeg | 200px]] | ||
| + | |||
| + | 5. Turn off the pump and switch the filter back to normal - position 1 - filter. | ||
| + | |||
| + | [[File:water_tab.jpeg | 200px]] | ||
| + | [[File:water_level.jpeg | 200px]] | ||
| + | |||
| + | 6. Top up the water level by opening the water tab valve until the water is in the middle of the pool outlet. | ||
Revision as of 16:45, 18 June 2020
Back to ASTA
Contents |
Description
6m long, 3.5m wide and 3m deep (when filled) (photo Michael Cole)
Salinity zero and no chloride, so be careful not to contaminate.
Cover
Not installed yet
Water flow control
Not fully operational yet (power control missing)
Filer maintenance
Access the filter sysem by opening the hatch.
The filter needs to be cleaned about every month. When the pressure approaches the red area it is time to clean.
1. Start by turning off the filter pump.
2. Mount the exces pipe.
2.1 The drain needs to be opened, just pull the cover off (2 hands, mind your bag).
2.2 Take the drain pipe and mount it.
2.3 Open the blue valve.
3. Switch the filter to position 2 - backwash. It will reverse the flow in the filter and dump the debris into the drain-pipe.
Turn on the pump and let it stay in that position for 1-2 minutes.
4. Turn off the pump and switch to position 3 - rinse. It will use the normal flow in the filter, but dump any debris that in the filter output to the drain.
Turn on the pump for 10-20 seconds.
5. Turn off the pump and switch the filter back to normal - position 1 - filter.
6. Top up the water level by opening the water tab valve until the water is in the middle of the pool outlet.
