Drone compass calibration
From Rsewiki
(Difference between revisions)
| Line 16: | Line 16: | ||
Arduino with sensor calibration code. Sending raw data to app and receive the calibration data when send is pressed on the calibration app. | Arduino with sensor calibration code. Sending raw data to app and receive the calibration data when send is pressed on the calibration app. | ||
| + | The calibration is saved in the Teensy EE-prom and will be loaded by the sensor library. | ||
Revision as of 08:46, 11 October 2020
back to [[Drone control]
Calibration setup
Once the controller is mounted on the drone, it is time to calibrate the compass.
Upload the calibration firmware to the Teensy (using the Arduino GUI)
Run the calibration app - in the bin directory for Linux, or here for other platforms https://www.pjrc.com/store/prop_shield.html
Calibration app - with a fair set of values.
Arduino with sensor calibration code. Sending raw data to app and receive the calibration data when send is pressed on the calibration app. The calibration is saved in the Teensy EE-prom and will be loaded by the sensor library.
