ASTA motion capture
From Rsewiki
(Difference between revisions)
(→Installation (as performed in August 2020)) |
|||
| Line 3: | Line 3: | ||
@todo | @todo | ||
| − | == Installation | + | == Installation as performed in August 2020 == |
=== Mount cameras on joints and joints on clamps === | === Mount cameras on joints and joints on clamps === | ||
Revision as of 22:17, 30 January 2021
Contents |
Description
@todo
Installation as performed in August 2020
Mount cameras on joints and joints on clamps
Make sure that the camera is not upside-down.
Prepare 16 safety ropes
- Cut to 1 m length
- Use a lighter at both ends
- prepare 8-knots as for rock climbing
Mount cameras on truss and wire them with the two switches
Mount the 16 cameras in the corners and at each 1/4 of the edges. Use the safety ropes, and wire them to the two switches as below.
Orient cameras and adjust focus
Once the setup is up-and-running, adjust the focus of each camera using a marker at 2/3 of the working distance. Skype and screen sharing may be helpful.
In the corners
The bottom of FoV is parallel to the long edges, and the bottom right corner is vertical.
At 1/4 of a short edge
The top of the FOV is horizontal, and the camera points toward the center.
At 1/2 of a short edge
The bottom of the FOV is vertical, and the camera aims downward.
At 1/4 of a long edge
The top of the FOV is horizontal, and the camera points toward the center.
At 1/2 of a long edge
The bottom of the FOV is vertical, and the camera aims downward.
