|
|
| (11 intermediate revisions by one user not shown) |
| Line 1: |
Line 1: |
| − | This is some suggestions for changed settings for Robobot.
| + | Moved to [[regbot settings]] |
| − | | + | |
| − | == Robot configuration==
| + | |
| − | | + | |
| − | Metric setup
| + | |
| − | | + | |
| − | The distance between driving wheels are different from a Regbot.
| + | |
| − | | + | |
| − | [[File:robobot_robot_settings.png]] | + | |
| − | | + | |
| − | == Control issues ==
| + | |
| − | | + | |
| − | Some examples of control settings.
| + | |
| − | | + | |
| − | ===Edge control===
| + | |
| − | | + | |
| − | For higher speed in the range 0.7-0.9 m/s the following control settings could be used.
| + | |
| − | | + | |
| − | [[File:line_edge_control.png]]
| + | |
| − | | + | |
| − | The control uses a Lag-controller to decrease the static gain by a factor 5 (a pole with a time constant of 1 sec and a zero with a time constant of 0.2 seconds). This means that the high frequency gain is Kp*0.2 = 0.06.
| + | |
| − | | + | |
| − | The gain is further scaled by the speed (from firmware version 604), so that the gain is reduced to half at 0.5m/s, but the filter times are maintained. This is probably a bad solution, as the response probably is more distance driven than time driven.
| + | |
| − | | + | |
| − | | + | |
| − | A test script to could be:
| + | |
| − | | + | |
| − | thread=1
| + | |
| − | vel=0.01, acc=5.0, log=20.0: time=0.2
| + | |
| − | vel=0.8, edger=0.7, white=1: dist=3.0, xw=20, log=0
| + | |
| − | label=3, event=3: xw<15
| + | |
| − | edger=-0.7, white=1: dist=1.5, xw=20, log=0
| + | |
| − | label=4, event=3: xw<15
| + | |
| − | edger=0.7, white=1: dist=1.5, xw=20, log=0
| + | |
| − | goto=3: count=1
| + | |
| − | vel=0.0: time=0.5
| + | |
| − | | + | |
| − | The mission follows right side of line,
| + | |
| − | * first in a left curve (1mØ) then
| + | |
| − | * a crossing line,
| + | |
| − | * wait for line to disappear,
| + | |
| − | * a right curve (1mØ),
| + | |
| − | * a crossing white line
| + | |
| − | * ...
| + | |
| − | | + | |
| − | The difference between a left and a right curve is the "edger=0.7" and "edger=-0.7", this makes the robot follow the curve with an offset of 0.7cm towards the center of the curve (more left in a left curve). This gives more space for overshoot when hitting the curve - the sensor range is about +/- 2cm.
| + | |
