Flexbot design

From Rsewiki
(Difference between revisions)
Jump to: navigation, search
(Design overview hardware)
Line 1: Line 1:
 +
Back to [[Flexbot]] main page
 +
 
==Design overview hardware==
 
==Design overview hardware==
 
Each "leg" of the flexbot consists of 3 actuators.  
 
Each "leg" of the flexbot consists of 3 actuators.  

Revision as of 13:02, 28 June 2017

Back to Flexbot main page

Design overview hardware

Each "leg" of the flexbot consists of 3 actuators.

  • An angled DC motor to control the wheel.
  • Two linear actuators to control the motion of the robot's body.

Each of these actuators is controlled by a μ-processor board (Teensy 3.2). The Teensy controls the actuators either directly or via a motor driver and receives feedback from the actuators encoder signals. A general hardware block diagram for a Teensy configuration is shown in Figure 1.

Flexbot teensy hardware blockdiagram.png

Figure 1: General hardware block diagram of the Teensy configuration.

Personal tools
Namespaces

Variants
Actions
Navigation
Toolbox