To do
From Rsewiki
(Difference between revisions)
(Created page with "=Flexbot design to do list= List of possible improvements ==Mechanics== * Design of legs is too wide - move support tubes (much) closer === Foot === ==== Motor and turn p...") |
(→Mechanics) |
||
| Line 6: | Line 6: | ||
* Design of legs is too wide - move support tubes (much) closer | * Design of legs is too wide - move support tubes (much) closer | ||
| + | * turn actuator motor inwards | ||
=== Foot === | === Foot === | ||
| Line 20: | Line 21: | ||
* Pinol hole to secure PCB should be shorter - or big entry hole. | * Pinol hole to secure PCB should be shorter - or big entry hole. | ||
* use higher temperature for orange PETG plastic (165 degree, not 162) | * use higher temperature for orange PETG plastic (165 degree, not 162) | ||
| + | |||
| + | ===Knee=== | ||
| + | |||
| + | ===Hip=== | ||
| + | |||
| + | ===Body=== | ||
Revision as of 11:21, 28 June 2017
Contents |
Flexbot design to do list
List of possible improvements
Mechanics
- Design of legs is too wide - move support tubes (much) closer
- turn actuator motor inwards
Foot
Motor and turn part
- Link between motor and wheel axle must be made in steel (not plastic)
- Turn (king-pin) bolt should be 5mm, and with bigger cone for the screw.
- Cut-out for motor, for raised ring on motor, should be bigger.
Big block
- Cut-out for teensy-print should allow more space for plugs.
- Space for shock absorber should be smaller.
- Width of block could be smaller.
- Pinol hole to secure PCB should be shorter - or big entry hole.
- use higher temperature for orange PETG plastic (165 degree, not 162)
