Fejemis Teensy
(→Software structure) |
(→Setup - loop overview) |
||
| Line 25: | Line 25: | ||
=== Setup - loop overview === | === Setup - loop overview === | ||
| − | + | The setup and loop structure follows the Arduino sketch format. The file is a C++ file as the compilation is using a Makefile rather then the Arduino IDE. | |
| + | |||
| + | The main file for the drive is fejemis.cpp and for the front Teensy is | ||
=== Module structure === | === Module structure === | ||
Revision as of 07:35, 29 July 2022
Back to fejemis
Contents |
Drive Teensy
Block diagram with all interfaces and interface protocol
Front Teensy
Block diagram with all interfaces and interface protocol
GUI
Using USB
Using the bridge
Software structure
Figure: The Teensy software is structured with a main loop and a number of units. After reset all units are initialized in a setup function, after that the main loop is entered. The main loop services the USB and send commands to the units for decoding. At regular intervals, the sample clock tick, all units are called to execute any sample time function. Most units are interfaces to external devices such as IMU, motor drive or distance sensor. There is further support units for e.g. control.
Setup - loop overview
The setup and loop structure follows the Arduino sketch format. The file is a C++ file as the compilation is using a Makefile rather then the Arduino IDE.
The main file for the drive is fejemis.cpp and for the front Teensy is
Module structure
One file one interface.
Subscription
Standardized setup of data subscription
Command decode
On-line help.
Configuration save
Use of configuration flash.
Update tick
Sample rate and sensor calculation
