Robobot linesensor description
(Created page with "Back to Robobot == Line edge sensor == === Sensor heat map === File:line-sensor-1_heatmap.png Figure. Line sensor values (normalized). After 0.3 sec a ...") |
(→Line edge sensor) |
||
| Line 5: | Line 5: | ||
=== Sensor heat map === | === Sensor heat map === | ||
| − | [[File:line-sensor-1_heatmap.png]] | + | [[File:line-sensor-1_heatmap.png | 500px]] |
Figure. Line sensor values (normalized). After 0.3 sec a line is detected. The robot is asked to follow the left edge. The robot is therefore turning left to have the left edge centered below the robot. | Figure. Line sensor values (normalized). After 0.3 sec a line is detected. The robot is asked to follow the left edge. The robot is therefore turning left to have the left edge centered below the robot. | ||
| Line 12: | Line 12: | ||
=== 3D view of sensor values === | === 3D view of sensor values === | ||
| − | [[File:line-sensor-1_mesh.png]] | + | [[File:line-sensor-1_mesh.png | 500px]] |
Figure. The same data as above is now shown with amplitude. The data is normalized so that calibrated white is 1000 and calibrated black is 0. The wooden floor has a level of about 400. The edge is detected with a threshold of 700, if any sensor is above 700, then a line is deemed to be valid. | Figure. The same data as above is now shown with amplitude. The data is normalized so that calibrated white is 1000 and calibrated black is 0. The wooden floor has a level of about 400. The edge is detected with a threshold of 700, if any sensor is above 700, then a line is deemed to be valid. | ||
| Line 18: | Line 18: | ||
=== Sensor values === | === Sensor values === | ||
| − | [[File:line-sensor-1_values.png]] | + | [[File:line-sensor-1_values.png | 300px]] |
Figure. The line becomes valid after about 0.3 seconds, here the left edge (red) is seen 6cm to the left (of the robot center line). The robot then turns left, a bit too much, and then keeps the left edge centered with the robot. | Figure. The line becomes valid after about 0.3 seconds, here the left edge (red) is seen 6cm to the left (of the robot center line). The robot then turns left, a bit too much, and then keeps the left edge centered with the robot. | ||
Revision as of 13:03, 28 December 2023
Back to Robobot
Contents |
Line edge sensor
Sensor heat map
Figure. Line sensor values (normalized). After 0.3 sec a line is detected. The robot is asked to follow the left edge. The robot is therefore turning left to have the left edge centered below the robot. After 2 seconds there is a crossing line to the right. After 4 seconds a crossing line is seen, both left and right.
3D view of sensor values
Figure. The same data as above is now shown with amplitude. The data is normalized so that calibrated white is 1000 and calibrated black is 0. The wooden floor has a level of about 400. The edge is detected with a threshold of 700, if any sensor is above 700, then a line is deemed to be valid.
Sensor values
Figure. The line becomes valid after about 0.3 seconds, here the left edge (red) is seen 6cm to the left (of the robot center line). The robot then turns left, a bit too much, and then keeps the left edge centered with the robot. The line width is estimated to be about 5cm, it is 4.3cm, so a bit over-estimated. After 2 seconds, the line width expands to about 7 cm, but this does not trigger the crossing line flag, as the threshold is set to 8cm. After 4 seconds a crossing line is detected.
