Inspection robot

Revision as of 13:46, 25 September 2014

Installation and use noted for 6-legged inspection robot.

The servo software is build upon the "Open servo" project, with a slightly modified PCB.

Green towards motor yellow center Red away from motor.

- or maybe more likely, motor is turned 180 deg.

At least 6.5V - to allow regulator to give 5V

Layout of servo-print with connections. Looks like Vbatt-P is connected to pot-, this can not be right?

P value must be set to (about 50) to make servo run. This gives some overshoot for large steps. A D-value makes it worse.

Need to investigate control-part of servo.

Update rate seems to be slow (~10Hz) investigate.

EMF sense is not in software

Current has some reaction, but no reaction to load? - investigate.

A new plugin is uploaded using USBISS converter to i2c - should be changed to i2c on target platform

Setting and main status for N servos (up to 24) implemented. Debug status for 1 servo implemented (first 48 registers are monitored)

Commands (write with register adress above 0x7f) is working

0x82 (130) enable PWM
0x83 (131) disable PWM
etc - see main.c in software

Change of i2c address is not implemented/tested (there is a save to eeprom command)

@@ Line 11: / Line 11: @@
 Green towards motor
 yellow center
-Red  away from motor
+Red  away from motor.
+- or maybe more likely, motor is turned 180 deg.
 * Power: