Schematic
From Rsewiki
(Difference between revisions)
| Line 6: | Line 6: | ||
[[File:Schematic_2.png]] | [[File:Schematic_2.png]] | ||
| − | Line sensor is | + | There is further allowed for additional interfaces: |
| + | |||
| + | * Line sensor - blinking LEDs at 1kHz and 8 sensors - connected to 8 A/D converters on the Teensy. | ||
| + | * IR distance sensors (Sharp 2Y0A21F) two, that is connected to 5V and A0 (IR1) and A1 (IR2) on the processor. | ||
| + | * Interface to Nordic Radio board with SPI interface (not in software yet) | ||
| + | * Serial interface (Teensy pin 0 (RX1) and 1 (TX1) (not supported by software yet. | ||
Revision as of 15:32, 2 January 2016
RegBot schematic revision 0.0
The teensy USB-5V connection to Vin is cut on the teensy-board, to allow 5V-PSU to supply in all cases.
There is further allowed for additional interfaces:
- Line sensor - blinking LEDs at 1kHz and 8 sensors - connected to 8 A/D converters on the Teensy.
- IR distance sensors (Sharp 2Y0A21F) two, that is connected to 5V and A0 (IR1) and A1 (IR2) on the processor.
- Interface to Nordic Radio board with SPI interface (not in software yet)
- Serial interface (Teensy pin 0 (RX1) and 1 (TX1) (not supported by software yet.
