Flexbot design
From Rsewiki
Back to Flexbot main page
Design overview hardware
Each "leg" of the flexbot consists of 3 actuators.
- An angled DC motor to control the wheel.
- Two linear actuators to control the motion of the robot's body.
Each of these actuators is controlled by a μ-processor board (Teensy 3.2). The Teensy controls the actuators either directly or via a motor driver and receives feedback from the actuators encoder signals. A general hardware block diagram for a Teensy configuration is shown in Figure 1.
Figure 1: General hardware block diagram of the Teensy configuration.
