Robobot hardware

Back to Robobot B

Hardware

Mounting holes

The hardware is 3D-printed plastic (except for the electronics and screws)

All 3D printed parts have holes for mounting additional parts. These holes have:

• Individual hole distance of 1cm.
• Hole diameter of 2.5mm, intended for 3mm plastic screws.
• Plastic thickness is 6mm in most cases.

Plastic screws

Mounting items on the 3D printed plastic should use plastic screws.

Plastic screws:

• Cut into the plastic with a sharp thread.
• Gets locked in the plastic and will not shake loose.