Regnot settings for Robobot
From Rsewiki
(Difference between revisions)
|
|
| (14 intermediate revisions by one user not shown) |
| Line 1: |
Line 1: |
| − | This is some suggestions for changed settings for Robobot.
| + | Moved to [[regbot settings]] |
| − | | + | |
| − | == Robot configuration==
| + | |
| − | | + | |
| − | Metric setup
| + | |
| − | | + | |
| − | == Control issues ==
| + | |
| − | | + | |
| − | Some examples of control settings.
| + | |
| − | | + | |
| − | ===Edge control===
| + | |
| − | | + | |
| − | For higher speed in the range 0.7-0.9 m/s the following control settings could be used.
| + | |
| − | | + | |
| − | [[File:line_edge_control.png]] | + | |
| − | | + | |
| − | A script to test could be:
| + | |
| − | | + | |
| − | thread=1
| + | |
| − | vel=0.01, acc=5.0, log=20.0: time=0.2
| + | |
| − | vel=0.8, edger=0.7, white=1: dist=3.0, xw=20, log=0
| + | |
| − | label=3, event=3: xw<15
| + | |
| − | edger=-0.7, white=1: dist=1.5, xw=20, log=0
| + | |
| − | label=4, event=3: xw<15
| + | |
| − | edger=0.7, white=1: dist=1.5, xw=20, log=0
| + | |
| − | goto=3: count=1
| + | |
| − | vel=0.0: time=0.5
| + | |
| − | | + | |
| − | The mission follows right side of line,
| + | |
| − | * first in a left curve (1mØ) then
| + | |
| − | * a crossing line,
| + | |
| − | * wait for line to disappear,
| + | |
| − | * a right curve (1mØ),
| + | |
| − | * a crossing white line
| + | |
| − | * ...
| + | |
| − | | + | |
| − | The difference between a left and a right curve is the "edger=0.7" and "edger=-0.7", this makes the robot follow the offset by 0.7cm towards the center of the curve (more left in a left curve).
| + | |
Latest revision as of 14:04, 17 March 2017
Moved to regbot settings
