Robobot hardware
From Rsewiki
(Difference between revisions)
(→Hardware) |
(→Hardware) |
||
| Line 4: | Line 4: | ||
[[File:robobot-design-2024.png | 400px]] | [[File:robobot-design-2024.png | 400px]] | ||
| + | |||
| + | ==Mounting holes== | ||
The hardware is 3D-printed plastic (except for the electronics and screws) | The hardware is 3D-printed plastic (except for the electronics and screws) | ||
All 3D printed parts have holes for mounting additional parts. These holes have: | All 3D printed parts have holes for mounting additional parts. These holes have: | ||
| − | * Individual hole distance of 1cm | + | * Individual hole distance of 1cm. |
* Hole diameter of 2.5mm, intended for 3mm plastic screws. | * Hole diameter of 2.5mm, intended for 3mm plastic screws. | ||
* Plastic thickness is 6mm in most cases. | * Plastic thickness is 6mm in most cases. | ||
| + | |||
| + | ==Plastic screws== | ||
| + | |||
| + | Mounting items on the 3D printed plastic should use plastic screws. | ||
| + | |||
| + | Plastic screws: | ||
| + | * Cut into the plastic with a sharp thread. | ||
| + | * Gets locked in the plastic and will not shake loose. | ||
Revision as of 12:44, 22 October 2023
Back to Robobot B
Hardware
Mounting holes
The hardware is 3D-printed plastic (except for the electronics and screws)
All 3D printed parts have holes for mounting additional parts. These holes have:
- Individual hole distance of 1cm.
- Hole diameter of 2.5mm, intended for 3mm plastic screws.
- Plastic thickness is 6mm in most cases.
Plastic screws
Mounting items on the 3D printed plastic should use plastic screws.
Plastic screws:
- Cut into the plastic with a sharp thread.
- Gets locked in the plastic and will not shake loose.
