ESP8266

From Rsewiki
(Difference between revisions)
Jump to: navigation, search
(Created page with "200px ==Hardware needed== For setting up the ESP8266 the following parts will be needed: * A fully functional RegBot programmed with latest version...")
 
Line 1: Line 1:
[[File:regbotVision.JPG|200px]]
+
[[File:esp8266.jpg|300px]]
  
 
==Hardware needed==
 
==Hardware needed==
Line 9: Line 9:
 
* A capacitor for stabilizing the output from the voltage regulator. E.g. 100uF.
 
* A capacitor for stabilizing the output from the voltage regulator. E.g. 100uF.
 
* A PC with an Arduino IDE installed (for easy serial communication).
 
* A PC with an Arduino IDE installed (for easy serial communication).
 +
 +
==Wiring==
 +
 +
Use a breadboard or through-hole prototype PCB to wire or solder the setup.
 +
 +
This model of the ESP8266(-01) has 8 pins as seen on the figure below.
 +
 +
[[File:esp8266pinout.png|400px]]

Revision as of 20:20, 18 April 2016

Esp8266.jpg

Hardware needed

For setting up the ESP8266 the following parts will be needed:

  • A fully functional RegBot programmed with latest version of the robot software. Consult this section to ensure that.
  • A ESP8266 WiFi Module.
  • A 5V to 3.3V voltage regulator.
  • A capacitor for stabilizing the output from the voltage regulator. E.g. 100uF.
  • A PC with an Arduino IDE installed (for easy serial communication).

Wiring

Use a breadboard or through-hole prototype PCB to wire or solder the setup.

This model of the ESP8266(-01) has 8 pins as seen on the figure below.

Esp8266pinout.png

Personal tools
Namespaces

Variants
Actions
Navigation
Toolbox