ESC calibration
(→Set to minimum 'stick') |
|||
| Line 41: | Line 41: | ||
Set values to 0 for all motors and press 'Apply manual values'. | Set values to 0 for all motors and press 'Apply manual values'. | ||
| − | The motors | + | The motors should now be quit and ready to go. |
== Test rotation direction == | == Test rotation direction == | ||
Use the GUI to set all motors to 10%, i.e. a value of 100. | Use the GUI to set all motors to 10%, i.e. a value of 100. | ||
Revision as of 17:34, 2 December 2020
Back to Drone control
Contents |
ESC calibration
The ESC used her is
- Hobbywing 40A 3-6 Lipo cell controller.
Manual is here: https://cdn.shopify.com/s/files/1/0109/9702/files/User_s_Manual_Xrotor-en.pdf?7945784144032874852
The calibration instructions are as in this figure, but use the GUI to set the ranges right.
Basic calibration instructions, but replace stick with GUI based calibration.
Gui based ESC calibration
NB!
- Remove propellers.
- Disconnect battery
Set to max 'stick'
With the controller connected to the PC and connected to the GUI, set the manual motor value to 1000, as shown below:
Click all mounted motors to manual, Set manual value to 1000 for all motors and press 'Apply manual values'.
Connect battery
Connect the battery and wait for the motors to beep.
Set to minimum 'stick'
Set all values to 0 as shown
Set values to 0 for all motors and press 'Apply manual values'.
The motors should now be quit and ready to go.
Test rotation direction
Use the GUI to set all motors to 10%, i.e. a value of 100.
