Drone control
From Rsewiki
(Difference between revisions)
(→Hardware - e.g. circuit diagrams and interface pin description) |
|||
| Line 10: | Line 10: | ||
[[Drone control hardware]] | [[Drone control hardware]] | ||
| − | [[File:schematic_rev0.png | 150px]] | + | #[[File:schematic_rev0.png | 150px]] |
== Drone software == | == Drone software == | ||
Revision as of 09:44, 21 December 2020
Drone project
This project is intended to be a rather simple core drone stabilizer application based on Teensy and the prop shield.
Intended to be expanded with an outer control loop with a non-realtime sensor, e.g. GNSS, camera or laser scanner.
Contents |
Hardware
Build on a hand-wired PCB as a prototype
Drone software
Magnetometer calibration
Calibration is used using a calibration version of firmware and a calibration app from Prop Shield manufacturer.
ESC calibration
The drone control uses ESC pulse width from 1 to 2 ms, and all ESCs should be calibrated to use this range.
