Drone control hardware
From Rsewiki
(Difference between revisions)
(→Flight controller) |
(→Servo power board) |
||
| Line 47: | Line 47: | ||
==Servo power board== | ==Servo power board== | ||
| − | [[File:servo_distribute.png | | + | [[File:servo_distribute.png | 500px]] |
| − | [[File:servo_distribute_PCB.png | | + | [[File:servo_distribute_PCB.png | 500px]] |
| − | [[File:servo_distribute_PCB_man.png | | + | [[File:servo_distribute_PCB_man.png | 500px]] |
Interface and power board for servos | Interface and power board for servos | ||
Revision as of 11:55, 5 May 2023
back to Drone control
Contents |
Flight controller
Version 1.2 schematic and PCB-layout. Sonar height is connected to RX4 same pin as A12 (marked as A12 on board) and 5V. Angle IMU for motor angles are GY91 boards connected to I2C-2, using pin 3 (SCL) and 4 (SDA) marked on board as ESC 1 (SCL) and ESC2 (SDA), both on 3.3V from pins marked A13 and 3.3V. Current measurements are not used (one is shorted). ESC 1 and 2 are moved to ESC 7 and 8.
Prop Shield
From: https://www.pjrc.com/store/prop_shield.html
Signal Pin # Used By: Description
SDA 18 sensors I2C Data for motion sensors
SCL 19 sensors I2C Clock for motion sensors
IRQ 2 sensors Interrupt from motion sensors
MOSI 11 memory,led SPI Data
MISO 12 memory SPI Data
SCK 13 memory,led SPI Clock
MEM_CS 6 memory Low to access memory
LED_EN 7 led High to send LED data
LED_DAT - led 5v buffered LED Data output
LED_CLK - led 5v buffered LED Clock output
AMP_EN 5 amp High to enable amplifier
AudioIN DAC amp Audio signal
AudioGND AGND amp Audio ground
Speaker+ - amp Connect a 4Ω or 8Ω speaker
Twisted pair wire is recommended
Speaker - - amp
5Vpower VIN amp,led
3Vpower 3.3V sensors,memory
GND GND (all)
Schematic
Sensor board
Servo power board
Interface and power board for servos
Power distribute
Power distribution from 2 batteries in parallel using XT60, all output sockets are XT30.
