Robobot on Raspberry PI

From Rsewiki
Revision as of 10:07, 24 December 2020 by Jca (Talk | contribs)

Jump to: navigation, search

Back to Robobot

Contents

Software packages

Install the following paxkages on the Raspberry to get, run and maintain the Robobot software

sudo apt install subversion  # to get the source code
sudo apt install 


Get ROBOBOT and REGBOT source

This is probably installed already, otherwise use

cd
svn co svn://repos.gbar.dtu.dk/jcan/regbot
ln -s regbot/mission
ln -s regbot/robobot_bridge
ln -s regbot/qtgui

Update ROBOBOT source

On the raspberry there is the following directories:

$ cd
  ls
  mission          Mission software skeleton that can also access the raspberry camera
  qtgui            Copy of the configuration gui (python files), and a windows executable in the 'dist' subdirectory
  regbot/regbot    Firmware for the REGBOT part
  robobot_bridge   The connection software between the REGBOT, the small display, the remote control and the mission software

Update

All these source directories are already connected to a SVN repository, but probably need update, by

cd 
cd mission
svn up
cd ../qtgui
svn up
cd ../regbot
svn up
cd ../robobot_bridge
svn up

Compile

If there are updates, then they need a recompile (except qtgui).

Mission and Robobot_bridge has a 'build' subdirectory with a Makefile, REGBOT has the Makefile in the base directory.

Type

cd ~/robobot_bridge/build
make -j4
cd ~/mission/build
make -j4

to compile

If there is no makefile in the build directory, then make one first by

cd build
cmake ..

REGBOT software

The REGBOT software is in the ~/regbot/regbot directory

To compile it for the REGBOT version 4 hardware with a Teensy 3.5 processor board, go to the '3.5' subdirectory

cd ~/regbot/regbot/3.5
make -j4

If successful a regbot.hex file is generated and should be uploaded to the REGBOT Teensy 3.5 processor.

This can be done from a console with X-messages enabled.

ssh -X local@solvej.local

if the robot is 'solvej'.

NB! While programming all the pins on the processor are released, including the one maintaining power to the robot. This means that the red button on the board MUST be pressed during the MAKE UPLOAD command

cd ~/regbot/regbot/3.5
make upload

See the regbot directory for more details.

Personal tools
Namespaces

Variants
Actions
Navigation
Toolbox