Regbot version 4
From Rsewiki
Back to Regbot.
Back to Robobot.
Introduction
Version 4 has motor controller on-board and support for servos. This version is powered by a Teensy 3.5 processor (128 kB RAM and 512kB PROM at 120 MHz).
PCB: savner 12v output til ekstern PSU (raspberry, LED m.v.), udtag efter MOSFET switch. savner PWM+direction+enable output til extern motor controller.
Schematic and board
Figure 1. Schematic - click to get a readable version.
Figure 2. PCB layout
Figure 3. REGBOT main board with annotated connectors.
Figure 4. Version 4 board in place.
